Brother Project Runway Cs5055prw Manual

How do you thread a bobbin on a brother CS5055PRW?

Put the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right.

Turn the bobbin clockwise, by hand, until the spring on the shaft slides into the notch in the bobbin.

Make sure to pull out 7 to 10 cm (2-3/4 to 3-15/16 inches) of thread from the hole on the bobbin..

What should the tension be set at on a Brother sewing machine?

If your presser foot wasn’t raised while threading the sewing machine, rethread and be sure to raise your presser foot so the thread can go into your machine’s tension disk. Also, be sure to set your tension dial between 4-5.

What should my tension be on my Brother sewing machine?

Correct thread tension The upper thread and the bobbin thread should cross near the center of the fabric. Only the upper thread should be visible from the right side of the fabric, and only the bobbin thread should be visible from the wrong side of the fabric.

How do you thread a bobbin?

Still, you can use this step-by-step guide to get you through the basics on any sewing machine.Start with an empty bobbin and a spool of thread. … Begin passing thread into the bobbin winder. … Secure the thread. … Insert the bobbin onto the bobbin winder shaft. … Secure the bobbin. … Begin winding.More items…•Mar 25, 2021

What does F4 mean on a Brother sewing machine?

Brother Authorized Service Center LocatorError code F04 or F4 indicates there is a problem with the unit and recommends the unit to be serviced. Brother Authorized Service Center Locator.

What does E5 mean on a Brother sewing machine?

You receive the error message E5 when the start/stop button was pressed while the foot controller was connected. 1. Disconnect the foot controller, and then press the Start/Stop button. – Otherwise, operate the machine by using the foot controller.

Why Does My Brother sewing machine say e1?

The foot controller was pressed (or the start/stop button was pressed if the foot controller is not connected) and the reverse/reinforcement stitch button was pressed while the presser foot is raised. Lower the presser foot lever before continuing the operation.

What tension should I use on my Brother sewing machine?

between 2 to 6. b.The tension dial should be set between 2 to 6. b. When the upper thread is just visible on the back of the fabric, the thred tension is correct.

How do I fix e1 error on my Brother sewing machine?

The foot controller was pressed (or the start/stop button was pressed if the foot controller is not connected) and the reverse/reinforcement stitch button was pressed while the presser foot is raised. 1. Lower the presser foot lever before continuing the operation.

Which Brother sewing machine is best for beginners?

Below are just a few of our best sewing machines for home use: Brother CS7000I | 70-Stitch Computerized Sewing Machine with Wide Table: This beginner sewing machine comes with built-in stitches, 10 included accessory sewing feet, and an automatic needle threader that sewers of all skill levels will love.

How do I reset my Brother sewing machine?

Reset Your Brother MachinePress [Settings]>[All Settings]>[Initial Setup]>[Reset]. If your machine displays the [All Settings] menu on the Home screen, skip the [Settings] menu.Swipe up or down or press or to display the type of reset functions, and then press the reset function you want to use. … [Machine will reboot after resetting. … Press .Feb 11, 2020